Dry ice

Dry ice

Dry ice, sometimes referred to as “cardice” , is the solid form of carbon dioxide. It is used primarily as a cooling agent. Its advantages include lower temperature than that of water ice and not leaving any residue (other than incidental frost from moisture in the atmosphere). It is useful for preserving frozen foods, ice cream, etc., where mechanical cooling is unavailable.

Dry ice sublimes at −78.5 °C (−109.3 °F) at Earth atmospheric pressures. This extreme cold makes the solid dangerous to handle without protection due to burns caused by freezing (frostbite). While generally not very toxic, the outgassing from it can cause hypercapnia due to buildup in confined locations.

Carbon dioxide  gas is pressurized and refrigerated until it liquifies. Next, the pressure is reduced. When this occurs some liquid carbon dioxide vaporizes, causing a rapid lowering of temperature of the remaining liquid. As a result, the extreme cold causes the liquid to solidify into a snow-like consistency. Finally, the snow-like solid carbon dioxide is compressed into either small pellets or larger blocks of dry ice.

Đá khô hay CO2 rắn- Đá khói

Larger block of dry ice

Dry ice is typically produced in two standard forms: blocks and cylindrical pellets. A standard block weighing approximately 0,5-1 kg is most common. These are commonly used in shipping, because they sublime relatively slowly due to a low ratio of surface area to volume. Pellets are around 1 cm (0.4 in) in diameter and can be bagged easily. This form is suited to small scale use, for example at grocery stores and laboratories where it is stored in a thickly insulated chest

Đá khô dạng viên

Dry ice- pellet 3mm



The most common use of dry ice is to preserve food, using non-cyclic refrigeration.

It is frequently used to package items that must remain cold or frozen, such as ice cream or biological samples, without the use of mechanical cooling.

Dry ice can be used to flash-freeze food or laboratory biological samples, carbonate beverages, and make ice cream

đá khô dùng làm lạnh bảo quản

Dry ice- Flash freeze food


One of the largest mechanical uses of dry ice is blast cleaning.  Dry ice pellets are shot from a nozzle with compressed air, combining the power of the speed of the pellets with the action of the sublimation. This can remove residues from industrial equipment. Examples of materials removed include ink, glue, oil, paint, mold and rubber.  Dry ice blasting can replace sandblasting, steam blasting, water blasting or solvent blasting. The primary environmental residue of dry ice blasting is the sublimed CO2, thus making it a useful technique where residues from other blasting techniques are undesirable. Recently, blast cleaning has been introduced as a method of removing smoke damage from structures after fires.

vệ sinh đá khô

Dry ice- blasting machine

Vệ sinh đá khô

Dry ice- cleaning

Dry ice- Rubbermold

Dry ice- Rubbermold


In laboratories, a slurry of dry ice in an organic solvent is a useful freezing mixture for cold chemical reactions and for condensing solvents in rotary evaporators. Dry ice/acetone forms a cold bath of –78 °C, which can be used for instance to prevent thermal runaway in a Swern oxidation.

The process of altering cloud precipitation can be done with the use of dry ice. It was widely used in experiments in the US in the 1950s and early 60s before being replaced by silver iodide. Dry ice has the advantage of being relatively cheap and completely non-toxic. Its main drawback is the need to be delivered directly into the supercooled region of clouds being seeded.


Prolonged exposure to dry ice can cause severe skin damage through frostbite, and the fog produced may also hinder attempts to withdraw from contact in a safe manner. Because it sublimes into large quantities of carbon dioxide gas, which could pose a danger of hypercapnia, dry ice should only be exposed to open air in a well-ventilated environment. For this reason, dry ice is assigned the S-phrase S9 in the context of laboratory safety. Industrial dry ice may contain contaminants that make it unsafe for direct contact with foodstuffs.

Contact: INDOCHINA GAS ., JSC – Mr Khanh +84 904 999 494